The entire production streaming line is fully enclosed in negative pressure, and dust and dust pollution will never occur at the production site. Adopting PLC programming control, security measures are multi -pronged, and parallel work is required. As long as one of the measures is required to effectively play a role, it can prevent hidden safety hazards. In terms of safety, inert gas protection airflow crushing classifiers mainly have the following characteristics: isolation of oxygen. In the process, the oxygen content is continuously monitored by the oxygen content in the airflow. When it exceeds a certain degree, nitrogen is immediately replenished, so that its oxygen content is always within the safety production standard. Control gas powder concentration: The feeding system for equipment supporting is a fully closed and uniform speed device, which is controlled by the control cabinet by programming. The fully enclosed plays a role of isolation of oxygen, and the atly of controlling the internal material concentration of the device is controlled at a constant speed. Release static electricity in time and eliminate the ignition source: The pulse anti -blowing collector uses a special filter material with carbon steel wire, which can eliminate static electricity in time, while ensuring that the pulse is cleaned and clean. The device is a all -metal component, all ground to release the powder static electricity as much as possible. Cool cooling: explosion -proof dustproof, emergency stop.
The operating process of the air flow crusher is mainly divided into before, after booting, shutdown, maintenance and precautions. Below Qingdao Youmingke Fan Machinery will introduce the detailed operation process of the air flow crusher.
1. Preparation before booting
Check the host, attachment, pipelines, and valves, whether it is intact and whether it can work normally.
2. Put up
(1) Open the power supply valve, the dust collector pressure valve, and the main gas valve in turn, and then turn on the power switch of the air flow crusher and connect the power.
(2) Start the hierarchical wheel from scratch and gradually adjust to the specified speed.
(3) Open the fan, the whirlwind separator out of the fans, the removal of the removal, and the power supply power supply, and then open the total power supply of the feeding warehouse, set the frequency of the frequency frequency, and then start the material for crushing.
(4) The granularity of the finished product can be adjusted through the hierarchical wheel frequency and the amount of feeding.
3. Disclosure
The order of the shutdown is: the inverter \u0026 mdash; , Dust MDASH; Fan \u0026 mdash; Total power supply \u0026 mdash; air compressor.
4. Maintenance
(1) The motor should be lubricated regularly, but the lubricating oil should not be excessive to avoid the temperature of the bearings from being too high.
(2) The wear of the hierarchical impeller, spiral feeder, and crushing nozzle should be paid attention to check.
(3) Message materialsAfter a certain period of time, clean up the adhesion of the machine to avoid blocking, which affects the crushing effect.
(4) After the filter bag is used for a period of time, clean up, or replace it.
5. Note
(1) When the unloader is running, the unloading exit cannot reach into the hand to avoid accidents.
(2) The speed of the impeller cannot exceed the regulations, otherwise the temperature will be too high and damage the impeller and motor.
(3) Safety valves should be checked regularly to ensure safety.
Under the strong advocacy of the country, \"green sustainable development\" is the main direction of the development of major enterprises.While practicing intelligent manufacturing, the implementation of green manufacturing in an all -round way has long been the top priority of the development of Youmingke powder machinery.You Mingke Pink Machinery Practice the concept of green manufacturing, and fully builds enterprises into a model for the transformation and upgrading of traditional manufacturing.