The entire system of the airflow crusher uses a closed crushing treatment. The dust is also very small, the noise is also very low, and the production process is also very clean and environmentally friendly. Therefore, the airflow crusher is a crushing equipment that meets environmental standards, which is highly appreciated by the powder processing users.
The feed device of the airflow crusher is usually high -pressure gas inhalation, screw fees and screws. It is the standard of vertical turbine classifier. Simultaneous grinding and grading. Adjust the speed of the classifier through frequency conversion, you can adjust the fineness of the product arbitrarily. If a processing process requires more than one particle size segment, two or four classifiers can be added on the basis of a standard classifier to make the machine a crusher and classification classifier of two to five. Generally speaking, there are some sounds in the operation. When the airflow crushing machine crushes the raw material, there will be a broken sound, which is normal. However, if the sound becomes noise, the sound becomes too loud. So how to solve excessive noise? Let's take a look at it. 1. Add lubricating oil to the rotating component. If the bearings and bearing dislocate, the adjustment will be adjusted; if the bearing is worn, the bearings will be replaced. 2. Noise will also be generated during the crushing process. The cooling sleeve, allocating water in the crushing room, can be used to reduce the temperature. 3. Install the muffler on the fireplace in the crushed room. 4. Linking device, such as using the damping board. Therefore, when we choose and buy a airflow crusher, we should choose a good one. In order to avoid unnecessary faults, no matter whether the feeder is a dual screw pipe or not, there is more More optimization technology. Not only the dual screw -type feeder is better, but compared to the pressure and feed pressure, the crushing effect of a crusher with a large pressure pressure is generally better, such as air compressors. It is a pressure of 8 kg, so the crusher can work under the pressure of 8 kg, but the feed pressure of some crusher is greater than the pressure of the crusher. Then at the pressure of 8 kg, this crusher must first ensure that the feed pressure pressure must be ensured It is 8 kg, and the pressure of the crusher is less than 8 kg, otherwise there will be a rebound phenomenon. It is best to have only one crusher at the entrance because APIS is more valuable. If there are two or three materials at the import, such as two or three materials at the same time, the grain size of these three materials will be different. At that time, it was impossible to mix these three materials evenly, which would cause great waste and trouble. For equipment with more than kilograms, it is recommended to use grinding beds with large filtration area. The production process is relatively continuous, not stop, and it is not easy to block. The above is the phenomenon of how much noise is solved by the airflow crusher compiled by the editor. Do you understand it more? The air flow crusher is one of the main products of Qingdao Youmingke. The product is technical advantage with high accuracy, high efficiency, and stability. It has a high reputation in various industries. Test, welcome new and old users to call for negotiationCooperation.