When the airflow crusher is cleaned, the total power can be turned off, and the remaining dust in the machine can be removed directly with the brush. It must be remembered to clean layer by layer. After removing the feeding bucket, you can remove the four screws on the base first, and then remove the furnishing bucket. After removing the sieve network, you can directly open the airflow crushing machine door, and the sieve can be sieved after ZUI. Before use, check whether all fasteners are tightened and the direction of the main axis is correct to avoid damage to the machine. Lubricating work in accordance with regulations so that the machine can run normally. Mixed things to avoid damaging the crusher. If there is any foreign or debris in the airflow crusher, it should be processed in time to avoid damaging the knife.
During the use of the airflow crusher, if there is abnormalities, it should be processed immediately to avoid greater losses. Some components should be checked regularly, such as regular inspection, such as Damage should be replaced immediately. The non -matching transportation device will cause the blockage of the drainage pipe wind to weaken or calm. To find out the failure, first of all, the export transportation equipment should be clearly clarified, without changes, adjust the amount of materials, and the normal operation of the equipment. Under the influence of a fan, the material is graded through the feed imported air. Separation through centrifugal separation to separate the material. After the separation, the particles meet the requirements, enter the rotor, and then collect it. If the particles do not meet the requirements, then further separate until it meets the requirements. The crushed materials entered the hierarchical room with the rise of the airflow, and the materials that reached granularity requirements entered the collection system through the impeller grading. The particles that did not meet the particle size requirements returned to the crushing room to continue crushing. The entire production process was fully closed and continuously operated without dust pollution.