The airflow crusher is a large -sized solid raw material crushed to the machine that requires size. Based on the size of the crushed or shattered materials, the crusher can be divided into crusher, medium fragment, fine mill, and ultra -micro crushing machine. In the crushing process, there are four types of external forces that are used for solids, cutting, cutting, impact, and grinding. Press rolling is mainly used in thick and medium crushing, suitable for crushing of hard and large materials; cutting is mainly used in fine shattered, suitable for crushing of tough material; impact is mainly used for medium, fine grinding, ultra -fine grinding, suitable for suitable grinding, suitable The crushing of crispy materials; grinding is mainly used in fine grinding, ultra -fine grinding, suitable for crushing of small pieces and fine particles.
Sometimes our operational methods and settings will make the crusher crushing items poor effect. Whether it is to increase the speed of the sideline or settings Parameter can't play a good effect, so what should I do for this situation? Increasing the speed of feeding, the principle of air flow crusher mainly depends on the high -speed airflow to make the material and the grown between the pink powder and the inner wall and the inner wall to achieve the broken effect. If the feed is too small, it will not be able to achieve the intense collision of Frequency, so that the strength cannot be reduced. In addition, if the wind door is too large, the internal negative pressure is too large, and the collision will be reduced. On the contrary, the positive pressure is not good. If the above two methods cannot be a good crushing effect, then you may wish to clean the airflow crusher to try, or it may be that dust and other effects affect the efficiency of work. The airflow crusher is brought out of the crushing room by the negative pressure airflow caused by the crushed material, entering the material collection system, filtering through the filter bag, the air was discharged, the materials and dust were collected, and the crushing was completed. It is widely used in chemical industry, minerals, metallurgy, abrasives, ceramics, refractory materials, medicine, pesticides, food, health products, new materials and other industries. Under the negative pressure airflow driven by the airflow crusher, the turbine grading device set by the top is driven by the top -level. The fine powder is forced to pass the classification device, and the cyclone collector and the bag dust collector are captured. The centrifugal force is thrown to the wall and sinks back and returns to the crushing cavity to continue crushing. In addition, you need to pay attention to these matters when using the airflow crusher, otherwise everything is empty. 1. In the process of production (PRODUCE), the temperature rise of the bearing must be performed frequently. When the temperature rise exceeds 50 ° C, it should be stopped for inspection to find out that the remove failure is excluded. 2. When the new machine is running, the drive belt is easy to extend. Pay attention to adjust the proper tightness of the belt to ensure the working life of the belt. By changing the ordinary air from the gas source into an inert gas such as nitrogen, carbon dioxide gas, etc., the aircraft can make this machine a inert gas protection equipment. It is suitable for crushing and grading of flammable and explosive, oxidation and other materials. 3. Easy -to -prone parts should be inspected frequently to replace the quality and production of production (Produce) in a timely manner. 4, knifeFilms and circles should regularly inspect wear (a basic type of parts of parts). If the production rate is reduced after wear, the product rate is reduced.5. The host and classification liquid bearing (Bearing) are lubricated, using No. 2 special lipid, 265-295.6, bearing (Bearing) fat exchange period is 2000 hours, the filling amount of lubricating oil is internal space in the bearing cavity cavity cavity cavity cavity cavity cavity cavity cavity cavity space.1/2 (last test) or 3/4 (below) Cut without filling too much lubricating fat, otherwise it will cause the bearing temperature to be too high.7. The spiral feeder's fat change period is 4,000 hours, Gapita calcium (CA) base lubricant.