Let's talk about the operating procedures of the airflow crusher and the vacuum machine. Below is the operating process of the airflow crusher and the vacuum feeder. Everyone has a general understanding of the airflow crusher, but not many, so I will introduce it next, because its content is not only these, but also other aspects, and it is also very important, then the following is a detailed explanation.
The airflow crusher compressed the air and was filtered and dried, and sprayed into the crushing cavity at a high speed through the Laval nozzle. The material is repeatedly collided, friction, cutting, and crushing. The crushed materials are moved to the hierarchical zone under the effect of rising airflow under the wind turbine. Under the powerful rotation of the high -speed rotating turbine, the thick and thin materials are separated, which meets the granularity size and meets the particle size. The required fine particles are collected through a hierarchical wheel into the cyclone separator and the dust collector, and the thick particles drop to the crushing area to continue crushing. The loss of the loss of the loss of the airflow crusher is low, and all the damage parts use high -quality wear -resistant materials at home and abroad, with a long service life. A small amount of easy wear parts is made of special hard abrasion, with a small size, light weight, and easy to replace accessories. The ultra -micro crushing machine consists of a warehouse, mechanical crusher, fans, whose aircraft, vibration sieve, liquid nitrogen tank, etc. The deep -cold crusher system uses liquid nitrogen as a cold source, and is crispy by the crushed material to achieve crispy crispy at low temperature at low temperature. After being easy to crush, enter the mechanical crushing machine cavity, rotate high -speed, materials and leaves, teeth, and materials between the materials and leaves, the material and the material and the material, and the crushing effect is achieved under the comprehensive effects of each other. 1. Whether the preparation of the preparation of the preparation of the host, the attachment, the pipe and the valve, etc., whether it is intact and whether it can work normally. 2. Start (1) Open the power supply valve, the dust collector pressure valve, the main air air valve, and then turn on the power switch of the airflow crusher to connect the power supply. (2) From scratch, the hierarchical wheel is gradually adjusted to the specified speed. (3) Open the fan, whirlwind separator, dust discharge, send the motor power, and then turn on the total power supply of the feeding warehouse, set the frequency of the frequency frequency, and then start the feeding crushing. (4) The particle size of the finished product can be adjusted by the frequency and amount of feeding in the hierarchical wheel. 3. The order of the shutdown is: the inverter -the feeder -main air air valve -compressor -hierarchical impeller motor -whirlwind dust collector, dust removal and electric switch -fan -total power -air compressor. 4. Maintenance (1) The motor should be lubricated regularly, but the lubricating fat should not be too much, so as not to be too high. (2) The wear of the hierarchical impeller, the spiral feeder and the crushing nozzle should be observed. The tension of the belt should be appropriate. (3) After the material is crushed for a period of time, the powder attached to the machine should be cleaned to avoid blocking and affect the crushing effect. (4) After using the filter bag for a period of time, it must be cleaned or replaced. 5. Precautions (1) When unloading the lotus, the outlet cannot be extended into the hand to avoid accidents. (2) The speed of the impeller should not exceed the specified value, otherwise the temperature is too high, the impeller and electricityOpportunities are damaged.(3) Check the safety valve regularly to ensure safety.Welcome to choose the operating procedures for the airflow crusher and vacuum supply machine.