Since the launch of the airflow crusher, the work efficiency of all walks of life has also been improving, and it has a pivotal position in the pharmaceutical, chemical, food and other industries. Pay attention to.
First, the airflow crusher usually uses the direct connection between the motor and the broken device, which is easy to maintain. However, if the two cannot be connected well during the assembly process, it will cause the overall vibration of the airflow crusher. A. The rotor of the motor is different from the rotor of the airflow crusher. The position of the motor can be moved on the left or right side of the motor, or it can also be moved on the pad at the bottom of the motor to regulate the concentricity of the two rotors. B. The rotor of the air flow crusher is different. The reason is that the two branches of the rotor shaft are not in the same plane. You can insert copper skin at the bottom of the bearing seat, or increase the adjustable wedge iron at the bottom of the bearing to ensure that the 2 axis head is concentric. C. The vibration of the airflow crusher is large. The reason is that on the flat hammer in the center of the rotor or the rotor, the coupling between the coupling and the rotor is uneven. According to different types of coupling, the corresponding method of coupling the motor is used. When the quality of the hammer is not equal, it is necessary to choose each group of hammer to make the symmetrical hammer less than 5G. The above is the content of the common problems of the air flow crusher. The company has always followed the standardized management and provides the product and service of the first production and service policy of the first production and service.