The airflow crusher commonly used in diamond processing is a super microcritical device. During the long -term use process, there will always be more or less abrasion phenomenon in many parts, which is unavoidable. Qingdao Youmingke is a manufacturer specializing in the production of diamond gas flow crusher. It can be proposed by this. Below is the editor who talks about the wear and phenomenon of the components of the airflow crusher.
In fact, the component of the airflow crusher wear is gradient, and the phenomenon is gradually revealed, so we are in the process of use. It is important to note that when a certain failure occurs, you can first see if it is caused by the wear of parts.
wear site
Phenomenon
Holocated wheel wear
Speed \u200b\u200bspeed gradually increases, and motor vibration increases
feeding valve wear
]Early feeding time becomes longer or shorter, and the amount of feeding cannot be controlled in severe cases
Hierarchical motor bearing
The feeding time becomes shorter
The grinding cavity pressure rises, the feeding time becomes longer
Differential valve wear
The discharge time becomes longer
The filter is blocked
Decreased pressure (sealing gas, protecting gas, anti -blowing)
The above is the introduction of the components of the air flow crusher. If the equipment fails due to wear, it needs to be replaced or maintained at this time. You can contact the original manufacturer directly to consult or purchase. The airflow crusher produced by Qingdao Youmingke has a low failure rate and high quality. It can be applied to the fields of ore, chemical, battery new materials, metal materials, rare earth materials, functional ceramics and other fields.