The two processes of crushing grading are generally at the end of the powder processing process, so it has a great impact on the performance of the final finished product. For example, in the battery material, crushing is an important link. If the crushed products are not qualified or over crushing, the rate of finished product will be greatly reduced. For battery materials with high prices, this loss cannot be estimated. Therefore, whether the battery material produced by the airflow crusher can reach the qualified particle size, and it is particularly important without crushing and large particles. When consulting the airflow crusher, many users will ask whether the airflow crusher can reach the nano -level. The following editor will answer this question for everyone.
The airflow crusher is an ultra -micro crushing device, not a nanometer crushing equipment. Only 200nm can be called nano. level. The performance parameters are D97, 2-45um, that is, the fineness can achieve 97%and about 2um. If it is about 50%or the average particle size, it is about 0.5-1um. Not all materials can meet this requirement, so the airflow crusher cannot meet the nano. The initial fineness of the raw material is related to the physical properties of the material. The liquidity in the material and the uniformity of the particles are related. Some materials have poor fluidity, many impurities, and high solvent content. There may be blocking materials during the production process. At this time, dedicated equipment is needed. Not all materials can be crushed with standard equipment to achieve crushing fineness. It is related to the crushing pressure in the crushing process. Some equipment inlet pressure is greater than crushing pressure. It is related to the speed of feeding, not all the material fluidity is very good. Whether it is used to use screw inlet or vibration, the feeding process is a very important factor. When you need to use a dedicated personalized configuration to achieve the feeding effect. Therefore, the good way for a certain material ZUI is to do a test first to see the effect. Do not ask if you ask some kind of machine to achieve the details. The same machine crushes other materials to reach D100 \u0026 LT; 2 microns, but right right, but right Another material may not reach D90 \u0026 LT; 5 microns. The above is the answer that Xiaobian can answer the air flow crushing function can reach nano -level. After understanding, I believe that everyone has a brand new understanding. The air flow crusher is widely used in chemical, minerals, metallurgy, abrasives, ceramics, refractory materials, medicine, pesticides, food, health products, new materials and other industries. For more information about air flow crusher Oh ~