In daily use, there will often be some small problems. In the use of
In the use of airflow crusher
It is a headache because he affects the efficiency of the machine and its processing accuracy. Today, I will bring a blow to understand how to reduce the speed difference in the air flow crusher.
\u0026 emsp; Why does the speed difference inside the air flow crusher? This is mainly because there is a difference between the hammer and the hammer of the hammer and the material in the machine, so the speed difference will occur. If this speed difference is not handled, it will affect the work efficiency of the crusher. Therefore, how to reduce the speed difference inside the machine is important, so what measures can be taken? There are the following points:
Measures 1: Proper adjustment of the hammer screen gap
\u0026 emsp; \u0026 emsp; adjust the hammer screen gap to improve efficiency. However, if you consider the service life of sieves and hammer pieces, and its wear, then this measure cannot solve the problem for a long time.
\u0026 emsp; \u0026 emsp; measures 2: Reasonable use of the opposite burrs of the sieve
\u0026 emsp; \u0026 emsp; After the sieve holes are polished, there is no effect.\u0026 emsp; \u0026 emsp; measure 3: Increase the wind suction
\u0026 emsp; \u0026 emsp; The degree of wear also increases the power absorption.
\u0026 emsp; \u0026 emsp; above is the solution to how to reduce the speed difference between the air crusher introduced by Xiaobian to you. When we use machines, we must pay attention to observing the operation of the machine, and we must solve the problem in time. Only in this way can the machine be maintained and improved production efficiency.