The medicinal ultra -micro crushing machine is an extension of the rough powder of Chinese medicine, but unlike the ultra -micro powder in other industries, it should pay attention to many aspects when crushing Chinese medicine. Such as the complexity of the medication parts of Chinese medicine, including flowers, leaves, roots, stems, and whole plants. The nature of various parts is very different. From the cell level, it from the outside to the inside. , Cortex, skinny parts, formation layers, wooden parts, rays, etc. are composed of different types of cells, which constitute cells such as thin wall cells, stone cells, ducts, wood fiber, and wood embolism cells. Another example is that the nature of Chinese medicinal materials in different varieties is different, such as three -seven quality, yellow and soft and sticky, and astragalus fiber strong. What are the uniformity of Chinese medicine ultra -micro powder other than three -seven varieties, and it is necessary to further study from different super micro -crushing technologies, evaluation indicators, and according to different properties. Qingdao Youmingke Plum Machinery introduces the method of thickness adjustment of medicinal ultra -micro crushing machines.
The fineness adjustment method of the medicinal ultra -micro crushing machine, the medicinal ultra -micro crushing machine under normal working state, the factors that affect the fineness are air volume and the speed of the hierarchical wheel speed, the speed of the hierarchical wheel The degree of feeding and the degree of wear of loss of parts. When the fineness is too thick: if the weight is the maximum, first reduce the feeding amount, and then increase the frequency of the grade wheel; if the requirements are not available, turn off the small air volume (the butterfly valve on the high pressure wind tube). This repeated adjustment, the finding and the fineness requirements of the pharmaceutical ultra -micro crushing machine are the control point of the best output. When the fineness is too fine: first increase the air volume, if the air volume is the maximum, reduce the frequency of the hierarchical wheels to increase the amount of feeding after the current decreases. Repeated adjustments, finding and reaching the fineness requirements are the best output control point.
The medicinal ultra -micro crushing machine was checked before booting. The newly installed equipment, when the device is in place and connected to the warehouse In the absence of the fan and the main motor, open the mixed board under the port to allow the impurities and warehouse materials to discharge from below. After the end, open the ultra -micro powder observation door to check whether there is impurities in the crushing disk, check whether the gap between the hierarchical wheel and the upper end is about 0.5mm. For the debugging of the medicinal ultra -micro crusher, after everything is normal, the device is powered on. Set the parameters of the two frequencies of ultra -micro -powder feeding motors and classification motors. Check the motor rotation direction. Adjust the width and gap between the veins of the dust collector's solenoid valve, and check whether the spraying of the solenoid valve is normal. Check whether there is a wind leakage in the turbine. You can use your hand or fine powder to be placed at the interface. If you have a lot of suction inside, you must seal it. After everything is normal, the order of booting in the future is: turn on the hierarchical wheel, set the frequency to high frequency (35Hz), start the high-voltage fan (after the start is normal) -Mori motor (after the start is normal)-turn on the feed motor to view the main electrical current current (Do not exceed the rated current of the main motor). At this time, the fineness of the finished powder is performed in the finished area. When the fineness exceeds the indicator, the hierarchical rotation speed can be adjusted down. Every time the speed of the hierarchical wheel is adjusted, for a period of time, the sampling test of the finished powder is taken. Every timeWhen the speed of the rating decreases, the current of the host will decrease, and at this time, the feeding frequency can be gradually increased to increase the crushing output.At the same time, the opening range of the high pressure fan wind door is adjusted.The current of the high -voltage fan of the drug ultra -micro crusher must not only ensure a certain air volume, but also allow the fan to work normally for a long time.If due to material differences, when the output and fineness are not reached, the rotation direction of the hierarchy can also be the same as the host rotation direction.Other debugging methods are the same as above.