Airflow pulverizer does not have traditional equipment wear problems, effectively improvement

Tea airflow grinding equipment, mainly consisting of MQW series pulverizer. According to the water content of the tea, the varieties of tea, the production capacity requirements are different, and the gas flow grinding of the manufacturing production. The product has: small wear, high precision control, can fully achieve the characteristics of uniform particle size distribution. Tea fine powder dedicated gas flow can be widely used in tea micron-level experiments and production.

Ultrafine powder is an important component of the product, which can improve and improve the product such as strength, elasticity, wear resistance, anti-high temperature, aging resistance, anti-radiation, and so on. And greatly reduce the production cost of the product. Ultrafine powder has different granular grades, 500 megadownload megadownload megadownload megadownload megadownload megadownload megadownload megadownload megadownload megadownload megadownload megadownload megadownload megadownload megadownload At present, the equipment for making ultrafine powder is divided into dry crushing and wet pulverization, and in the dry pulverization equipment, the gas flow pulverizer is called leader processing equipment, because the airflow pulverizer can achieve general crushing equipment The ultra-fine particle diameter is not reached, and there is no pollution-free dust during the processing, which is ideal for today's environmental situation, and has become a favorite of many processing companies.

The host of the airflow pulverizer does not have any moving parts, nor without any motor and other transmission, the high pressure air generated by the air compressor instantly released the inside of the pulverizer through the airflow nozzle of the pulverizer. There is no traditional "grinding", "grinding ball", "grinding ball", "grinding rail", and the material is driven by high pressure air, and the mutual collision is achieved by high pressure air. The entire pulverization process does not have a traditional long-term pressure and friction, and the material is pulverized by itself, and the pulverization process and equipment are not suitable for high hard, high purity, thermal material, and there is no traditional equipment wear problem. . The main cause of the bearing overheating and damage caused by too much, too little or aging in the bearing, so according to the filling quantitative use of lubricants, generally lubricated bearings from 70% to 70% space, too much or too little Not conducive to bearing lubrication and heat transfer. Extend the life of the bearings. The matching bearing cover is tight, the bearing and the shaft fit are too tight or too loose to cause the bearing overheating. The bearing should be disassembled, complete the friction portion, and then reassemble it as needed.
Since the gas flow crusher, the work efficiency of all walks of life has alsoIncreased, in the minerals, chemicals, new materials and other industries have a pivotal position, Shandong Yemu is the source manufacturer of gas flow crushers. It has provided tens of thousands of equipment and production lines at home and abroad for 23 years. Erp The airflow pulverizer can be free from experiment and test.