How to choose manufacturers and models for lithium iron gland mill

Inert gas protection airflow explosion explosion. The whole system has explosion-proof holes in different positions in the whole line, which minimizes the loss during the bursting and explosion caused by the internal pressure and concentration of the system. The motor and other devices used in the whole system are explosion-proof motors, and the sealing performance is better, which effectively reduces the accumulation of dust.

Ultrafine powder has different granular grades, 500 megadownload it is common to refer to fine powder, 500-10000 mesh is ultra-fine and ultrafine powder. For example, most of the materials used in battery materials need to pass through the ultrafine treatment, it can enter the next application. Taking lithium iron phosphate as an example, it is generally required to proceed to the micron fine powder. The production process of lithium iron phosphate is generally super finely grinded with a sand mill, then dried, and then uses a gas flow pulverizer or mechanical grind to the ultrafine powder, and the following small series is mainly to guide the airflow pulverizer.

In recent years, the battery positive material is rapidly developed. Many manufacturers who produce lithium iron phosphate want to expand production capacity to improve efficiency, but they are very confused when they choose a gas flow. There are a lot of machine manufacturers, I don't know how to find quality, service, good equipment suppliers.
For the choice of manufacturers and models of the iron phosphate lithium gas flow crusher, it is mainly based on the following factors:
1, production capacity;
2, pulverized particle size;
3, particle size distribution range and Distributed curve;
4, supplier's technical capabilities
Can not only look at the size of the manufacturer, it is best to go to the test during the purchase, and the airflow in the test area of ​​Shandong Yelai Powder Technology Co., Ltd. Machine samples can be tested, please feel free to book.
After the airflow pulverizer is installed, please refer to the operating instructions for trial operation. If there is no problem, it can be pushed.
For the production commissioning of the airflow pulverizer, first confirm the size of the raw material and the granularity requirements after the crushing, and then gradually exploit the experimental data from the experimental conditions. Today we will briefly describe how to adjust the gas flow pulverizer to get the particle size of the desired end product.
First, determine whether the pulverization pressure, feed pressure and feed speed are determined, whether the product detection is consistent with the target particle size, how much the gap is, if the product being made, can maintain the pressure constant, increase the rate of expenditure, if ThickerTo consider reducing the speed of the feed, it is also possible to improve the product fineness by increasing pulverization pressure and feeding pressure, which requires gradual experimental debugging. Overall, it is to find a suitable combination by adjusting the three parameters of the gas flow crusher. It is necessary to obtain the desired particle size product.