CW130 type medicinal hammer Hammer Mill has a small size, aesthetic, easy to move, easy to operate, is composed of a pulverized hammer, a tooth plate, a crushing motor, a blade, and the like. The material is subjected to a pulverizing chamber by the feed, and the fine-rotating hammer is pulverized. The fineness can be adjusted at will. The special architecture is not effective, the noise is low, the safety is high, the performance is stable, the hygiene is clean, the loss is extremely low, the efficiency is high. The fineness is accurately adjustable; the high-speed rotating paging puts the required material from the pulverized chamber, and the material does not meet the required materials continue in the pulverizing chamber. This machine complies with GMP certification standards.
Medicinal Hammer Hammer Mill is made of stainless steel material, the internal (pulverized groove) all the tooth grooves are machined from the precision machine to achieve smooth surface smoothness, easy to clean, change the normal Hammer Mill inner wall rough, easy to concentrate powder , Difficult to clean up, making food, drugs, chemicals, etc., which can also meet national standards and reach GMP health requirements. Except for fine powder, it is also a crushing effect of crude particulate drinks for Jiugang, pearl, chemical raw materials, food raw materials, minerals, soil, food, coal, and experimental raw materials, which are pulverized brittleness. First modeling of materials. It is an ideal equipment for the current clinic, pharmacy, research institute, shopping mall, laboratory, colleges and universities, trial rooms, scientific research units, and families.
Medicinal Hammer Hammer Mill Precautions
1, before use, it is necessary to determine if the power supply voltage is normal, and the power socket has a reliable ground wire.
2, suitable for the ambient temperature of -5-40 degrees Celsius, relative humidity<90%，恒温最适宜，应放置通风、干燥、清洁的位置。
3, can not work for a long time, general medicinal material is pulverized for 1 minute, and special time is longer. The smashing time should not be too long, preventing the fine powder from being thermally sticking into a bowl. Don't cross for 5 minutes each time, the number of machining is required, and the middle must be rest, preventing the motor shaft from being damaged by the motor.4, when working, drugs do not exceed half of the Hammer Mill slot content. The dry material is smashed finer. Wet and grease items should not be processed.
5, when you just start, if you touch the crumbware cardTo make the motor not working properly, immediately turn off the power, prevent the motor from being damaged and clean up before you can re-work.