English

What is the blockage of the airflow crusher?

With the

airflow crusher

Powder equipment display diagram

, the application is becoming more and more extensive. In the process of using gas crying, there are sometimes some faults, such as The crushing opportunity was blocked and suddenly made us helpless. In fact, blocking is a common failure when the pieces crushed. The main reason is caused by the operation. Today, Qingdao Youmingke will teach you some tricks to deal with crushing machines.

Question 1: The speed of feeding is too fast, the load increases, causing blockage.

During the feeding process, pay attention to the large turn angle of the current meter pointer at any time. If the rated current exceeds the rated current, it indicates that the motor is overloaded and overloaded for a long time, and the motor will be burned. This situation should be reduced or closed immediately, and the method of feeding can also be changed to control the amount of feeding by increasing the feeder. There are two types of feeders: manual and automatic. Users should choose the appropriate feeder according to the actual situation. Due to the high speed, large load, and the fluctuations of the load are high. Therefore, the current of the pieces is generally controlled at about 85%of the rated current.

Question 2: If the discharge pipeline is not smooth or the intake is too fast, the crusher's air outlet will be blocked; improper matching with the transportation equipment will cause the discharge pipeline to weaken or block the wind without wind.

After detecting the failure, first clear the portal changes to the non -matching transportation equipment, adjust the amount of feed, so that the equipment runs normally.

Question 3: Hammer pieces are broken, aging, screen holes are closed and tattered. Excessive water content of crushing materials will block the crusher.

The hammer sheet that is broken and severe aging should be updated regularly, maintaining a good working state of the crusher, and checking the sieve network regularly. Do not block the crusher and enhance the reliability of the crusher. These are the ways to deal with

airflow crushing machine

. It is common to fail the machine. The most important thing is that we need to know the method of solving the problem. One factor.