Ultrafine pulverizer operation procedure 1, before the boot needs to be inspected, whether there is oil. 2. Remove the metal, sand, stone and other debris in the material to prevent damage to the machine. 3, hand must not reach into the feed port, and do not open the cover in the operation. 4, the sieve aperture must be appropriately selected, and the damage is required. 5. It is strictly forbidden to start the load, the machine is running more than one minute (jūn yún) feeding, and the appropriate amount of water will be injected. 6. Turn a second minute to clear the rest of the machine before the stop. Ultrafine pulverizer adjustment and maintenance 1, mainly damaged parts of the crusher: flat teeth, round tooth, large, small grinding. Flat teeth and round tooth steel processed, good dynamic balance, severe wear (a basic type of components failure) should be replaced, self-cultivation, SPECification, Spectations, each weight difference is not greater than 1 gram To avoid vibration damage to bearing and machine. 2,0.6-12 mm various different specifications of SPECifications. Airflow pulverizer and cyclone separator, dust collector, and airplane set into a set of pulverization systems. The main applicable pulverization mechanism determines its scope, high finished product, typical materials are: super hard diamond, silicon carbide, metal powder, etc. When replacing, the light surface is required. 3, Bearing regularly fill high-speed butter, and inspect once half a month, it is found that the serious wear (a basic type of component failure) should be replaced or repaired in time. 4. It is strictly forbidden to collide, and the long-term stop should be cleaned inside and outside, properly keep it to prevent rust. 5. All causes of manufacturing are not working properly, users can contact the manufacturer directly, free warranty. Ultrafine pulverizer machine maintenance and storage 1, often inspecting the fastening conditions of each component, preventing it from falling off, damaging the machine. 2. Each oil is often refueling, and the Bearing is cleaned every half year of the year to follow a lithium-based lubricant. 3. When there is a shutdown job, the machine should be idled for a period of time, the filler in the package, and then shut down. 4