The entire production flow line of inert gas protection airflow crushing classifiers uses a fully closed negative pressure cycle. Most of the PLC programming control is used to minimize the human operation and control factors. The control cabinet can be placed in a separate control room in the distance. Using automatic packaging machines, on -site observations use monitoring probes, which can be fully operated.
Today, the role of the laboratory airflow crusher in various types of processing industries cannot be underestimated. , Improved work efficiency and brought objective economic income. Therefore, it also fully illustrates the importance of the laboratory airflow crusher. After using the laboratory air flow crusher to complete the production task, what we should also do is to scientifically maintain the laboratory air flow crusher. 1. The operation and maintenance of the fans cleared the dust inside the fan every week, especially the ash dirt at the leaves. Add lubricating oil to the bearing box every month (2#calcium sodium base lubrication). In the process of turning on and running the fan, if there is abnormal noise inside the fan, or the fuselage vibration should be stopped immediately. 2. Check the wear of graded impeller, spiral feeder, and crushing nozzle every twelve months. After 200 to 300 hours of crushing materials, it is necessary to clean up and stick to the pink body on the nozzle, the inner wall of the grinding cavity, and the graded wheel to prevent crushing and classifying effects. It is necessary to clean up the filter or replacement at the normal work of the pulse valve for 200 to 300 hours. Hierarchical motor bearing lubrication. When it runs for 2000 hours, it must be appropriately added with molybdenum grease, and the amount of oil should not be added too much, otherwise the bearing temperature will increase. 3. During the operation of the planetary material outlet, if the abnormal noise is found, the inspection should be performed immediately. Clean up the impeller and the body in the body every three months. Inject 00#polar pressure lithium base every three months. 4. The operating maintenance of the pulse bag dust collector's operating environment is poor. Check it every three months and clean the dust. Check the intact situation of the filter bag every six months and replace it. If the air outlet is ash, it should check whether the filter bag is separated and damaged. Whether the frame pressure plate is loose, whether the sealing ring is aging, and replace it. Pulse controller and solenoid valve can be checked normally before booting every day. 5. Control cabinet control cabinet pay attention to dustproof, close the door of the control cabinet tightly in use to prevent dust from entering. Clean up the dust with trachea every half a month to prevent poor contact. The model, quantity, and accessories of the order equipment based on the contract to ensure that the stock preparation is fully matched with the order. After the production of the equipment is completed, the quality inspector is inspected by the quality inspection to ensure the production quality of the equipment to be installed. Before the equipment is packed, the packing list with a single member one by one will be packed one by one to prevent leakage and less hair. The equipment packing adopts professional packaging and modular solutions to ensure the safety and loss of equipment during the process of device transportation.
