The laboratory air flow crusher manufacturer tells us that the laboratory air flow crusher is more used in the industrial industry, such as a flat laboratory airflow crusher, an airflow crusher, and a fluidized bed Laboratory air crusher and other types of laboratory air flow pieces. Moreover, the laboratory airflow crusher is widely used because the laboratory air flow crusher itself has a special function, which can save a lot of manpower and effectively improve labor efficiency. Therefore It will be so common and extensive.
The laboratory air flow crusher still has certain problems in use, such as blocking. Once such problems occur, work cannot be done normally. As a result, the main reasons for this problem are: \u0026 emsp; \u0026 emsp; 1. The inlet speed of the laboratory air flow crusher is too fast, the load increases, causing blockage. During the feeding process, pay attention to the large turn angle of the current meter pointer at any time. If it exceeds the rated current, it indicates that the motor is overloaded and overloaded for a long time, and the motor will be burned. This situation should be reduced or closed immediately, and the method of feeding can also be changed to control the amount of feeding by increasing the feeder. There are two types of feeders: manual and automatic. Users should choose the appropriate feeder according to the actual situation. Due to the high speed, large load, and the fluctuations of the load are high. Therefore, the current of the pieces is generally controlled at about 85 % of the rated current. \u0026 emsp; \u0026 emsp; 2. The laboratory airflow crusher is not smooth or blocked too fast, which will block the crusher air outlet; improper matching with the transportation device will cause the discharge pipeline to weaken or be blocked after no wind. After detecting the fault, first clear the delivery of the non -matching transportation equipment, adjust the amount of input materials, and make the equipment run normally. \u0026 emsp; \u0026 emsp; 3. The laboratory air flow crusher is broken and aging, the screen holes are closed and tattered. Excessive water content of crushing materials will block the crusher. It should be updated regularly and breaking and severe aging, maintaining a good working state of the crusher, and checking the sieve network regularly. The water content of the crushed materials should be less than 14 %. Enhance the reliability of the crusher. You Mingke 7*24 -hour customer service hotline and 150+ service engineer standby at any time. Any problems in the production line can be complained to feedback. Youmingke will give a technical consultation to a technical consultation within 30 minutes. Provide clear solutions, and provide services to the fault on the 3rd (10th).
