Maintenance of ultra -micro crushing machines:
1, during the production process, the bearings temperature should be regularly inspected. And exclude failure.
2, the new engine, the transmission belt is easy to expand. Pay attention to adjusting the tightness of the belt to ensure the life of the belt.
3, the loss of damage must be checked frequently and replaced in time to ensure the quality and production capacity of production.
4, leaves, lining plates should be checked frequently. If wear and productivity are reduced, the grain size is gradually replaced and found to be thick.
5, the host and classification process are bearing lubricating lubrication, No. 2 special lubrication, 265-295. Lipid phase changes
6, bearing for 2000 hours, filling the amount of lubricating lubrication (test) or 3/4 (measurement) of 1/2 of the bearing cavity area, not too much oil filling bearing temperature is too high. Otherwise it will cause.
7, a fat spiral with 4000 hours, plus ordinary calcium -based lubricating fat.
8, the output shaft, that is, the belt wheel, avoid using hammer and damaged parts.
9, the handle of the handle is strictly prohibited. Lubricant 10, governor, N32 high -alkaline zinc anti -wear hydraulic oil.
10, lubricating oil gear reducer, cannot be replaced with other machines.
11, after 3000 hours, new oil should be replaced, and then 500 hours, second oil, and then 1,000 hours.