The application of airflow crusher is widely used, and what we want to introduce to you today is how to solve the problem of blocking the airflow crusher equipment. Let ’s take a look.
1. The feeding speed of the airflow crusher is too fast, the load increases, causing blockage. During the process of feed, always pay attention to the large deflection angle of the current meter pointer. If the rated current exceeds the rated current, it indicates that the motor is overloaded and overloaded for a long time, which will burn the motor. In this case, the door should be reduced or closed immediately and can change the feeding method. Control the feeder to increase the amount of feeding. There are two types of feeders: manual and automatic. Users should choose the appropriate feeder according to the actual situation. Due to the fast speed, large load, strong load volatility. Therefore, the current of the pieces is usually controlled by about 85%of the rated current.
2. If the discharge tube is not smooth or the feed is too fast, the blocking machine will be blocked. If it is not properly matched with the transportation equipment, the raw management will weaken or block after the wind. After the failure is detected, first clear-remove the transmitted device that is not matched with the material, adjust the amount of the material, so that the equipment runs normally.
3. Aging of hammer sheets, closed sieve nets, crushing, and crushed material water content will cause crushing machines to block. The broken and severe hammer head should be updated regularly to keep the crusher in a good working state and check the screen regularly. The moisture content of crushing materials should be less than 14%, which can not only improve production efficiency, but also prevent crushing machines from blocking. Improve the reliability of the airflow crusher equipment.
The above content is brought to you by the Qingdao Youming Keflow Message Machine, I hope it will be helpful to everyone.