We all know that once the ultra -fine crusher fails, it will affect its normal use. Let's take a look at the common fault exclusion methods of the ultra -fine crusher with the ultra -fine crusher manufacturer.
1. Reflex spray: Improper wind door adjustment, screening pipes, pipeline blocking, poor pink bags or poor breathability, severe wear of hammer and severity, etc. It will cause the feed and export anti -spray.
When this phenomenon occurs, the reasons should be found first, and then targeted measures should be taken, or the wind door is adjusted to remove the blockage, or the pink bag is replaced to increase the breathability, or the hammer is replaced.
2. Bearing overheating: When the bearings are lubricated, damaged or bending the spindle, severe imbalance of rotor, and the belt will be heated when the belt is too tight. By adding and replacing lubricating oil, replacement of bearings, main shafts, balanced rotor, and adjusting the tightness of the belt to make the bearings restore the normal state.
3. The crusher strong vibration: The following reasons may cause a strong vibration of the crusher:
① The installation of hammer pieces is error;
Excessive deviation;
③ Bearing damage or spindle bending;
④ The bottom of the foot connects the screw loose. If the hammer is arranged error, it should be reorganized according to the requirements of the instructions; if the weight deviation of the two groups of hammer pieces is too large, the weight should be balanced, so that the weight difference is not more than 5 grams; if the bearings are damaged or the spindle is bent, it should be replaced in time ; If the screws are loose to the bottom of the bottom, it should be tightened.