In the process of using the airflow crusher, various problems will always be encountered, especially for some novice friends, the airflow crusher is very difficult after the problem of the air flow machine It is also very headache. Let ’s take a look with the manufacturer of the airflow.
The gas flow crusher adds the feeder, and let the material use the speed of the material, the material is not going down. This situation is generally caused by the raw materials too fine. , So the stable feed speed will become a problem. Wenqiuli at the inlet of the feast will become smaller and smaller over time, resulting in blocking the material.
The material is blocked in the fragments, and the material is large. It forms a hard block on the crushing ring, resulting in the smaller and smaller of the crushing discs, and the crushing disk is blocked. The crushed materials are blocked at the material and blocked the outlet mouth. The crushed materials enter the dust collector through the pipeline, and some materials will block the conveyor pipeline, resulting in unable to produce normally.
Some materials cannot be completely adhered to the dust bag after crushing, resulting in unable to produce stops. Some materials are adhered to the feeding mouth of the feeder after crushing. Do not go down. If you use a vibrator, you do n’t get the material. Of course, there is also a fineness after crushing.