What is the reason for the laboratory small and medium -sized air flow crushing machine? The main reason is that the main reason is to define the spindle. We can use the processing method to correct or replace it. There is no fixed tight or looseness in the damage work. The method of processing is tight. Some other parts on the rotor are not very balanced. At this time damaged. Generally, it is a problem that can be processed with replacing new bearing. A single hammer film is too tight, and there is no fully throwing away in the work. At this time, we need to make manual observation after the shutdown. The rolling sensitivity exceeds 5 grams of the weight difference of the corresponding two sets of hammer pieces. The method we use is to use the weight of the hammer. When the video light machine hammer sheet is turned around, in order to avoid losing the balance of the rotor, all the hammer films in the crusher will be turned around. Essence
Precautions for the small airflow crusher device, during the process of using it, it should help fix the tooth dish and remove it. Just unload the bolts The first thing that needs to be done is to open the cabin of the crusher, and then unload the selected gear disk or a sword, obtain the maze and the bearing cover, and then remove the outer belt wheel and the bearing cover. The axis and the shafts and shafts from both ends are launched on both ends. When the device is performed, the shaft lining oil hole still keeps the oily eye. When the fragmentation machine sieves, the screen should be tightly attached to the inner shoulder groove of the cavity, otherwise the sieve ring is damaged when the door is closed. The manufacturing shattering ring, the opening length of the screen should be manufactured in the shoulder size of the sieve ring. If the screen is damaged, it should be matched with the manufacturer. Install the sieve net, the two sieve circles are aligned with the sieve network and then press the screen to the inner sieve.
Before the work is done, you must check whether all firms of the machinery in the machine before using the crusher is in a state of tightening, and whether the belt is tight. The working direction of the main axis needs to be working in the direction of the arrows indicated on the protective cover. Otherwise, it will directly break the machine. In severe cases, it will cause the death of life. Therefore In addition, you still need to check whether there are hard debris such as metal in the mechanical crushing room, otherwise the knife will be damaged to affect the machine work. The material must be viewed before crushing, and there is no mix of metal hard debris, so as not to hit the knife or cause burning. The oil cups on the machine should often be injected into lubricating oil to ensure that the machine works normally. Stop the feeding before stopping. Check whether the knife and screening network is damaged regularly. If it is damaged, it should be replaced immediately. Using the timing to understand a tiny oscillation, the laboratory air crusher must tighten the cover handle to avoid incidents.