The airflow crusher is used in many industries such as metallurgy, medicine and food, so it is widely used. The power of the airflow crusher is air, so driven by high -speed airflow, you can run at high speed, and then hit it to crush it. This supersonic crushing technology is crushed by the air purification of the air. Pollution can be crushed at low temperature, and it will not destroy the nutrition of food. After the effect of a whirlwind separator, the fineness can be a few microns.
With the continuous development of economy and science and technology, the scope of use of air flow crusher has also increased significantly, such as the pharmaceutical industry, industrial industry, food industry, etc. Other industries will use airflow crusher, but do you know how to choose airflow crusher models in different industries?
The manufacturer of the airflow crusher said that the difference between the air flow crusher used in different industries is obvious, such as their volume is different, especially in the laboratory and medicine The smaller the size of the airflow crusher used in the industry, because the small airflow crusher can not only reduce the loss, but also does not take up more space.
The manufacturer of the airflow crusher told us that although the smaller the air flow crusher in the pharmaceutical industry, the better the airflow crusher in the industrial industry or the food industry is better, because the industry The use of the industry and the food industry is also relatively large, especially the working efficiency of the air flow crusher is certain, but no matter which industry uses airflow crusher, we must clean up and maintain the airflow crusher to prevent airflow from airflow The use of pieces is affected.
The sample material size, and what effect the effect is to be crushed, how much disposal, the import is still a domestic brand, how much is the budget, according to these, you will have a approximate number in your heart.
Many customers of the air flow crusher must find a few airflow crusher manufacturers when choosing a airflow crusher. I suggest that when comparing here, I need to pay attention to the following issues:
] The feeder, whether the feeder is a double screw feeder, the dual screw feeder also has more optimized technology, not as long as the dual screw feed is the best,
Comparison of crushing disk pressure and feed feeding Pressure is generally better for crushing machines with large crushing disks. For example, the air compressor is 8 kg of pressure. Then, under the pressure of 8 kg, this kind of crusher must first ensure that the feeding pressure is 8 kg, and the crushing disk pressure should be less than 8 kg, otherwise it will appear anti -blowing phenomenon.
It is best to choose a crushing machine with a crushing disk without a nozzle when choosing a laboratory, because it is more troublesome to clean and install it with a nozzle.Easy to lose it.
There is only one crushing machine with only one receiving port, because the raw materials are relatively valuable. If it is crushed to receive the ingredients from different places at a time, such as two or three of the feed port, then these three materials, then these three materialsThe particle size will be different. It is impossible to mix these three materials evenly, which will cause great waste and trouble.
For equipment above the kg level, it is recommended to use a large filter area crusher. The production process is more continuous, it will not stop, and it is not easy to block.
Try to choose a simple structure, cleaning and installation will be more convenient, and there will be less material loss.
As long as you can master these points, you can choose a better airflow crusher.